Sand in Franklin, MA

Looking for sand in Franklin, MA? Ten Four Landscape Supply delivers sand across Franklin from our yard at 26 Industrial Rd in Wrentham, and we also load pickups right at the yard. Franklin is one of the busiest towns we serve, and it sits just west of the yard. So Franklin deliveries are frequent, quick and easy to schedule.

Sand delivery in Franklin, MA

The town has a lively downtown near Dean College and the Town Common, newer neighborhoods on its edges and wooded land around Franklin State Forest. It is also home to what is widely called the first public library in the country. Franklin has everything from compact downtown yards to large new-construction lots, so order sizes vary a lot.

Franklin orders for base material usually go toward driveways, paver patios and commercial lots near the highway. For that reason, sand is a regular order in Franklin. In short, our Sand is clean sand for leveling, bedding, backfill and mixing, and it is sold by the cubic yard.

Why Franklin customers choose our sand

Our sand is a clean, general-purpose sand sold by the yard. It spreads easily, levels well and compacts when wet. As a result, it handles most landscape and construction jobs around the home.

Sand is also easy to work by hand. For example, you can screed it flat with a board, tamp it with a hand tamper or wet it down to settle. That makes it a friendly material for DIY projects.

Popular uses for sand in Franklin

Homeowners and contractors in Franklin put sand to work in many ways. Here is where sand comes in handy:

• Leveling under pavers, patio stone and pools
• Bedding for pipes and utility lines
• Backfill around foundations and drains
• Filling low spots before loam and seed
• Mixing with loam to improve drainage
• Joint fill between stones (ask about polymeric products)

How much sand does a Franklin project need?

First, measure the area in feet and multiply length by width. Then multiply by the depth in inches and divide by 324. The result is cubic yards, which is how we sell sand. Under pavers, sand is used as a thin, screeded bed of about 1 inch. For leveling or filling, however, depth depends on how low the area is.

For example, a typical Franklin job of about 600 square feet needs roughly 2 yards at 1 inches, or 3.5 yards at 2 inches. Still, round up by half a yard for edges and settling. Or call (774) 372-1050, and we will check the math before the truck is loaded.

Delivery or pickup for Franklin, MA

We deliver sand in Franklin, MA by truck, placing the pile where you want it. Newer Franklin neighborhoods usually have wide, paved driveways. However, some downtown streets are tight, so mention parked cars or narrow access when you book.

1. Book the load. Call or send a quote request with the amount of sand and your Franklin address.
2. Pick the drop spot. Next, choose firm, open ground close to the work area, clear of wires and branches.
3. Protect the surface. Then lay a tarp or plywood on pavement, so cleanup takes minutes.
4. Meet the truck. Finally, the driver calls ahead and places the pile as close to your spot as the ground safely allows.

Picking up at the yard

For Franklin customers, the yard is a short drive east, so pickup is a practical option for smaller loads. As a rule, a full-size pickup carries about about 1 yard of this material safely. So check your payload rating, and bring a tarp for the ride back to Franklin.

When to order sand in Franklin

Base work goes best when the ground is dry and firm. So late spring through fall is the prime season in Franklin. In addition, plan driveway and patio projects before the first hard frost, because compaction is difficult on frozen ground.

How to screed sand for pavers

1. Compact the base. Build and compact a stone base first. Then check the slope with a level.
2. Set rails. Lay two pipes on the base as screed rails. Next, spread sand between them.
3. Strike it off. Pull a straight board across the rails. As a result, the sand bed is flat and even.
4. Lay the pavers. Place pavers on the sand without stepping on the screeded area.
5. Compact and sweep. Finally, compact the pavers and sweep fine material into the joints.

Sand in Franklin, MA: FAQs

More for your Franklin project

Sand usually works as part of a system. For instance, ¾″ bluestone forms a base, ⅜″ stone or sand sets the pavers, and loam finishes the edges. So if your Franklin project needs more than one material, see ⅜″ Bluestone in Franklin, ½″ Screened Loam in Franklin and ¾″ Bluestone in Franklin. As a result, one delivery can often cover the whole job.

We also deliver sand to nearby Wrentham, Norfolk, Medway and Bellingham. For depth tips, coverage and product details, read the full Sand guide, or see every town we serve. For local background, Franklin on Wikipedia is a good start.